While trying to run a Scala/Java mix project, I ran into a problem where Eclipse was successfully able to launch my program, whereas when I tried to launch the same program from the command-line, I faced one problem after another. After a lot of search-fix-find-new-problem cycles, I decided to find out exactly what was the command eclipse was launching. Obviously, Google to my rescue. I found this thread - http://stackoverflow.com/questions/1989419/eclipse-is-there-a-way-to-get-eclipse-to-output-the-commands-given-to-run-your-p
Just wanted to jot down the steps here again (these are reproduced as is from the above thread)
- Run your program inside Eclipse.
- Go to the Debug perspective.
- Terminate the program, or let it end. right click on the second line. (Terminated, exit value… ) and select properties. in there you will have the full command line used.